Please remember, this is a record of what I did. I hope you found this informative and useful.Įnd of Citroen Xsara – Seat hight adjustment lever repair. After that, it was just a mater of pushing the plastic cover in place over the lever and securing it with its screw.Īnd there it was! The seat hight adjustment lever fixed and the driver’s seat set at the lowest setting again! Just the way I like it! I then set the seat to the highest setting again, tightened that first (left) screw properly and brought the seat back to its highest setting. Alternatively, one could have someone else sit in the driver’s seat while placing the second screw. As you can see in the picture below, the holes were not perfectly aligned, and I had to “convince” them into place by pulling down on the lever. I set the seat to the lowest setting and started screwing the second screw on. The missing screws were exactly the same size and type as the one I removed from the plastic cover, and I happened to have a couple of those in my tool box, only with a Phillips head, instead of Torx.Īfter screwing the first screw I tested the seat hight adjustment and found it once again worked. I did not tighten it much though, as I later found out that it would make it difficult to correctly align the holes behind (to the right of) the lever. I placed the lever back on the protruding shaft as it normally is when the seat is set at the highest setting, aligned the holes in front (to the left) of the lever and screwed a new screw on. We stock a range of seat covers including fabric, sheepskin and waterproof options. Here’s a couple of pictures to satisfy your curiosity.Īnyway, doing that I saw there was another screw missing behind (to the right of) the lever. Find car seat covers for your Citroen C4 Grand Picasso (2014 to 2018). Although it did help me partly understand how the lever works, it also cost me some time trying to correctly reposition it. I later realised I probably needn’t have done that. This is its proper position and it may not have been like that when I first removed the plastic cover.Īnyway, I went on to remove the lever by pulling it outwards. Note that in this picture the hole on the lever’s metal plate is aligned with the corresponding hole on the seat’s chassis.
0 kommentar(er)
